Views
1 month ago

WINTER 2020

  • Text
  • Plating
  • Engineering
  • Zinc
  • Association
  • Industrial
  • Distributors
  • Products
  • Screws
  • Fasteners
  • Fastener
Distributor's Link Magazine Winter 2020 / Vol 43 No1

32 THE DISTRIBUTOR’S

32 THE DISTRIBUTOR’S LINK Larry Borowski President GREENSLADE & COMPANY INC. 2234 Wenneca Avenue, Fort Worth, TX 76102 TEL 817-870-8888 FAX 817-870-9199 EMAIL sales1@greensladeandcompany.com WEB www.greensladeandcompany.com WHICH SELF DRILLING SCREW SPECIFICATION SHOULD BE FOLLOWED? Most purchasers of self drilling screws do not indicate a particular specification when ordering. Therefore, manufacturers of self drilling screws must have a set of requirements they will routinely use when they are not given specific instructions by the buyer. There are three main standards that cover self drilling screw requirements. These standards are: SAE J78, JIS B1125, and DIN 7504. The requirements are similar, but not exactly the same. The following charts compare their major requirements: *Note: Test material should be cold rolled steel with a hardness of Rockwell B65-80. TECHNICAL ARTICLE CONTINUED ON PAGE 118

SHARE A PAGE FROM THIS MAGAZINE

OPTION 1: Click on the share tab above, or OPTION 2: Click on the icon (far right of toolbar) and then click on the icon (top right of the page).

View Archives

WINTER 2020
FALL 2019
SUMMER 2019
SPRING 2019
WINTER 2019
FALL 2018
SUMMER 2018
SPRING 2018
WINTER 2018
FALL 2017
SUMMER 2017
SPRING 2017
WINTER 2017
FALL 2016
SUMMER 2016
SPRING 2016
WINTER 2016
FALL 2015
SUMMER 2015
SPRING 2015
WINTER 2015
FALL 2014
SUMMER 2014
SPRING 2014
WINTER 2014
FALL 2013
SUMMER 2013
SPRING 2013
WINTER 2013
FALL 2012
SUMMER 2012
SPRING 2012
WINTER 2012
FALL 2011
SUMMER 2011
SPRING 2011
WINTER 2011

Copyright © Distributor's Link, Inc. All Rights Reserved | Privacy Policy